Release notes for the RME Digi96 family ======================================= This is a BETA TEST VERSION and there many features that are not implemented yet. Also some features may not work as intended yet. This version supports all RME Digi96 family members. Also the ADAT mode is supported. However the analog input port of Digi96/8 PAD is not supported yet. Adjusting the driver settings ----------------------------- There are several settings that can be changed using the ossmix program shipped with OSS. Note that some features don't work with all Digi96 family members. For example ADAT mode is not supported by the base model. digi96.mode (SPDIF|AESEBU|ADAT) currently SPDIF This setting controls the output mode which can be S/PDIF (consumer), AES/EBU (professional) or ADAT. The input mode is detected automatically. If ADAT input is detected the output mode will be switched to ADAT automatically (this doesn't work in the other direction.) digi96.sync (EXTERNAL|INTERNAL) currently INTERNAL This setting tells if the playback sampling rate is based on the internal oscillator or the sample rate detected in the input port. See also the definition of the digi96.worldclk setting. digi96.input (OPTICAL|COAXIAL|INTERNAL|XLR) currently OPTICAL Selects the active input. digi96.sel (BYPASS|NORMAL) currently NORMAL When set to BYPASS the input signal will be routed directly to the output (also sets digi96.sync automatically to EXTERNAL.) In this mode audio data written to /dev/dsp will be muted. digi96.worldclk ON|OFF (currently OFF) Setting this control to ON will enable the optional worldclock input as the sample rate source (overrides the digi96.sync setting.) digi96.emph ON|OFF (currently OFF) Enables/disables the de-emphasis option on the analog (monitor) output connector. digi96.data (AUDIO|AC3)currently AUDIO) Specifies if the output signal is audio or AC3 data (sets the non-audio bit in the channel status data.)